The VTech CS6929 is a DECT 6.0 cordless telephone with basic features including caller ID (subscription required), memory dialing (50 entries), adjustable ringer, and wall mount capability. It supports English and French, and is designed for simple residential use. Below are the key specifications, installation, operation, programming, and troubleshooting instructions.
Unpack the phone and ensure all components are present: handset, base unit, telephone line cord, AC adapter, battery pack, battery compartment cover, belt clip. For battery replacement: Insert battery pack into handset compartment (label "THIS SIDE UP"), slide cover into place. Charge new battery by placing handset in base cradle for 12 hours before first use. Maximum battery life: Up to 7 hours talk time, 5 days standby. Place base away from water, heat sources, and interference.
WARNING! Failure to read and follow all instructions carefully before installing or operating this control could cause personal injury and/or property damage. Save these instructions.
The VTech CS6929 is a DECT 6.0 cordless phone with built-in answering system (up to 99 messages, 3 minutes each), caller ID (subscription required), phonebook (50 locations, up to 30 digits/15 characters), redial (10 numbers), adjustable volume (5 levels), ringer (5 melodies/OFF), any key answer, chain dialing, and expandable to 5 handsets. Supports basic calling, paging, and remote access. Handset layout: Earpiece, LCD, CID/VOL−, /VOL+, switch dialing, INT, Microphone, dialing keys, * (pause/REDIAL), # (mute), OFF/CLEAR, END/POWER, SELECT/MENU, UP/DOWN, Speaker, Charging cradle. Base layout: IN USE, VOICEMAIL, ANS ON/OFF, /PLAY/STOP, X/DELETE, /VOL−, /VOL+, FIND HANDSET, Microphone, RJ11 jacks, Power jack, Wall mount bracket.
Applications: Residential cordless telephony; Single handset.
CAUTION! To prevent electrical shock/equipment damage, unplug before installation. Use only supplied adapters. If in doubt about wiring, consult qualified electrician.
WARNING! Do not use on circuits exceeding 120V AC; improper use can cause shock/fire. All wiring must conform to local/national electrical codes. Avoid use during storms, near gas leaks, or with medical devices (maintain 6-inch distance). Dispose of batteries per local regulations. Install DSL filter if using DSL/high-speed internet.
Plug telephone line cord into base and wall jack (use DSL filter if needed). Plug power adapter into base and unswitched outlet. Install battery in handset (align terminals, snap cover). Place handset in base to charge for 12 hours. For wall mount, attach bracket to base and wall plate, route cords through slots.
Terminal Designations: Telephone line jack for line cord on base; Power jack for adapter.
Standard Setup: Wall jack to DSL filter (if needed) to base telephone line jack; Power outlet to adapter to base power jack.
Wall Mount: Insert wall bracket tabs into base grooves, mount on wall studs.
CAUTION! All wiring must conform to local/national electrical codes. Do not use switched outlets.
After charging, lift handset and listen for dial tone (wait 1-2 seconds). Test by dialing a number and adjusting volume. Verify CHARGE light on base.
Redial: Press REDIAL/PAUSE, press PHONE to dial.
Access phonebook with /VOL+/ (directory).
Caller ID: /VOL-/CID > Scroll > PHONE to dial > SELECT > PROGRAM to save to phonebook.
Changes activate immediately.
Adjust via PROG: Date/Time, Ringer, Dial Mode, Home Area Code, Language.
| Setting | Default | Options | Comments |
|---|---|---|---|
| Ringer Tone | Tone 1 | 5 melodies | PROG > RINGER > Ringer tone > Sample > SELECT |
| Ringer Volume | Medium | OFF/HI/LOW | Hold VOL during idle or PROG > RINGER > Ringer volume |
| Handset Volume | Level 3 | 5 levels | Adjust during call |
| Language | English | English/French/Spanish | PROG > LANGUAGE |
| Dial Mode | Tone | Tone/Pulse | PROG > DIAL MODE |
| Quiet Mode | Off | On (24 hours) | Hold # to toggle |
| Voicemail Number | None | Up to 30 digits | PROG > VOICEMAIL # > Enter number > SELECT (hold # to retrieve) |
Set Time/Date: PROG > DATE/TIME > Enter MM/DD/YY, HH:MM > SELECT.
Clear Voicemail Indicators: PROG > CLR VOICEMAIL > SELECT.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Telephone does not work at all | No power, low battery. | Check adapters, charge 12 hours; unplug/replug power (15 sec); test with another phone. |
| No dial tone | Wiring issue. | Check line cord; test jack; contact provider for wiring/DSL/VoIP issues. |
| Poor audio quality | Out of range, interference. | Move closer; press CHAN; avoid electronics; install DSL filter; centralize base. |
| Cannot store numbers | Memory full (20 max). | Delete entries. |
| Handset does not ring | Ringer off. | Set ringer ON; check plugs; reinsert battery. |
| Voicemail indicators persist | Service provider messages. | Use CLR VOICEMAIL feature (does not delete messages). |
Handset Registration: Base: Press MENU > Register HS > Place handset in cradle.