The VTech CS6114 is a DECT 6.0 cordless phone system with caller ID, 30-name phonebook, redial, and adjustable ringer. It includes one handset and base, expandable up to 5 handsets, with handset speakerphone and backlit display. Below are the key specifications, installation, operation, programming, and troubleshooting instructions.
Verify all parts are included: Cordless handset, telephone base, battery pack (2.4V Ni-MH 300mAh), battery compartment cover, belt clip, handset charger, power adapter, telephone line cord, user's manual. Install and charge handset battery before use.
CAUTIONS: Use only supplied adapters and batteries. Save these instructions.
Handset Battery Installation: Open battery compartment cover, insert battery pack with label facing down, replace cover. Charge for 16 hours initially.
The CS6114 is a DECT 6.0 cordless phone. Handset layout: Earpiece, LCD display, navigation keys, dialing keys (0-9, *, #), VOL +/-, SPEAKER, MUTE/DELETE, REDIAL/PAUSE, PHONE/FLASH, INT, END/OFF, charging contacts. Base layout: Charging cradle, IN USE/CHARGE light, power jack, telephone line jack. Features: Caller ID, 30-name phonebook, redial (5 entries), speakerphone, backlit keypad. Range: 50 ft indoors, 300 ft outdoors.
Applications: Home cordless telephony.
CAUTION! To prevent electrical shock, unplug before cleaning. Use only in dry locations.
WARNING! Reduce risk of fire/shock: Do not use near water; avoid rough handling. Do not disassemble. Keep 6 inches from pacemakers. Use only specified adapter (Input: 120V AC 60 Hz, Output: 6V DC @400mA) and Ni-MH battery; risk of explosion if wrong. Dispose per local codes. Operate in 0°C - 50°C, 5%-95% humidity. Unplug during storms.
Base: Plug power adapter into base and outlet. Plug telephone line cord into base and wall jack. Charger: Plug adapter into outlet. Place handset in charger; CHARGE light on. Registration: Auto-registers when placed in base. For additional handsets, press MENU > Registration on base, then OK on handset.
CAUTIONS: Use supplied cords. Charge batteries 16 hours.
Charge handset 16 hours. Press PHONE for dial tone. Test incoming call: Rings, answer with PHONE. Test range within limits. If no tone, check connections and recharge.
Phonebook: Press MENU > Phonebook > Add contact, enter name/number > Save. Dial from phonebook: Scroll to entry > PHONE. Delete: Scroll > MUTE/DELETE > Yes. Redial: Press REDIAL, scroll to entry > PHONE.
Default settings indicated by asterisks (*).
| Setting | Default | Options | Comments |
|---|---|---|---|
| Ringer Volume | 2* | Off, 1-3 | MENU > Ringer |
| Speaker Volume | 3* | 1-5 | During call: VOL +/- |
| Language | English* | English, Español, Français | MENU > Settings > Language |
| Key Tone | On* | On, Off | MENU > Settings > Key tone |
Admin Access: MENU for settings.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| No dial tone | Line cord loose; not registered | Check connections; re-register handset |
| Handset does not ring | Ringer off; out of range | Adjust ringer; move closer |
| Poor audio | Interference; low battery | Reduce distance; charge battery |
| Cannot store phonebook | Memory full | Delete entries; try again |
| Battery not charging | Dirty contacts; faulty charger | Clean contacts; try another charger |
Care: Wipe with damp cloth. Dispose batteries properly. Service: 1-800-595-9511.