VTech 80-6113-00 AT&T E5812B User Manual

The AT&T E5812B is a 5.8GHz cordless telephone system with digital answering machine, caller ID, and dual handsets. It features a backlit display, speakerphone, phonebook (50 entries), call log (45 entries), redial (10 entries), adjustable ringer, voicemail indicator, and remote access. Supports English/Spanish/French. Below are the key specifications, installation, operation, programming, and troubleshooting instructions.

Preparations

Unpack the phone and ensure all components are present: telephone base, 2 cordless handsets, 2 rechargeable battery packs (2.4V 600mAh Ni-MH), 2 battery compartment covers, base power adapter (9V DC 210mA), telephone line cord, user's manual. Install batteries in handsets and charge for 16 hours before first use. Place base away from water, heat sources, and interference. Use wall mount bracket if desired.

WARNING! Failure to read and follow all instructions carefully before installing or operating this control could cause personal injury and/or property damage. Save these instructions.

Description

The AT&T E5812B is a cordless 5.8GHz phone with digital answering system (up to 40 minutes recording time). Features include backlit display, speakerphone, adjustable ringer, 50-name phonebook, 45-name caller ID log, 10-number redial, voicemail waiting indicator, call screening, remote access. Supports English, Spanish, French. Handset and base layouts include navigation keys, volume controls, dedicated buttons for mute, redial, find handset, INT.

Applications: Residential cordless telephony; Compatible with DSL/Caller ID; 2 handsets included.

Precautions

CAUTION! To prevent electrical shock/equipment damage, unplug before installation. Use only supplied adapters. If in doubt about wiring, consult qualified electrician.

WARNING! Do not use on circuits exceeding 120 VAC; improper use can cause shock/fire. All wiring must conform to local/national electrical codes. Avoid use during storms, near gas leaks, or with pacemakers without consulting doctor (maintain 6-inch distance). Dispose of batteries per local regulations. Install DSL filter if using high-speed internet.

• WARNING! Use only the power adapters provided with this product.
• WARNING! Install the DSL filter if using DSL Internet service.

Specifications

• Electrical: Frequency: 5.8GHz; Power: 120V AC, 60Hz; Adapter: 9V DC @ 210mA.
• Batteries: 2.4V 600mAh Ni-MH rechargeable; Charge time: 16 hours; Talk time: Up to 7 hours; Standby: Up to 5 days.
• Range: Up to 50 feet indoor; Varies by location.
• Operating Ambient: 32°F to 122°F (0°C to 50°C); Humidity: Up to 95% non-condensing.
• Dimensions: Handset: Approx. 6.7 x 2 x 1.1 inches; Base: Standard size.
• Other: Phonebook: 50 entries; Caller ID: 45 entries; Recording Time: 40 min; Languages: English/Spanish/French; Handsets Included: 2.

Removing Old Phone

Shut off power if applicable. Remove old phone cover. Label wires before disconnecting. Disconnect wires one at a time; do not let fall into wall. Remove old base from wall.

Installation

Plug telephone line cord into base and wall jack (use DSL filter if needed). Plug power adapter into base and unswitched outlet. Install batteries in handsets (connector first, label up, slide cover). Place handsets in base/chargers to charge for 16 hours. For wall mount, attach bracket and slide base into place. Register additional handsets via MENU > Registration.

Wiring Diagrams

Terminal Designations: RJ11 jack for line cord on base; DC jack for power adapter.

Standard Setup: Wall jack to DSL filter (if needed) to base RJ11; Power outlet to adapter to base DC jack.

Wall Mount: Route cords through bracket slots.

CAUTION! All wiring must conform to local/national electrical codes. Do not use switched outlets.

Check Operation

After charging, lift handset and listen for dial tone. Test by dialing a number and adjusting volume. Verify CHARGE light on base.

Basic Calling

1. Press /FLASH, enter number.
2. To answer: Press /FLASH or any dialing key.
3. Adjust volume with VOL+/-.
4. End call: Press OFF/CLEAR or place in base/charger.

Answering Machine

1. Press ANS ON/OFF on base to turn on.
2. Record announcement: Menu > Answering sys > Announcement > Record.
3. Test by calling from another phone; messages record automatically.

Intercom

1. Press INT, enter extension number.
2. Answer: Press /FLASH or dialing key.
3. Transfer call: Press INT during call, enter number.

Caller ID

View via CID; new calls with icon. Dial back with /FLASH. Save to phonebook via SELECT.

Operating Features

• Home Screen: LCD shows time, date, battery, signal, new messages icon.
• Key Features: Speakerphone, mute, chain dialing, ringer volume/tone, key tone on/off, voicemail indicator, remote access, find handset.
• Range Limits: Volume: 5 levels; Ringer: 5 levels + off.

Programming

Access menu with MENU/SELECT. Set date/time, program phonebook, configure ringer.

1. Set Time: Menu > Settings > Set date/time > Enter MM/DD/YY, HH:MM > SELECT.
2. Phonebook Entries: Menu > Phonebook > Add contact > Enter number/name > Save.
3. Run: Exit menu; changes activate immediately.

Configuration

Enter menu via MENU/SELECT. Adjust LCD language, key tone, ringer volume/tone, voicemail number, call block.

Troubleshooting