The VTech 6727 is a 2.4GHz cordless telephone with answering system, featuring caller ID (subscription required), phonebook storage (up to 50 entries), redial (last 10 numbers), adjustable ringer and volume, voicemail indicator, and expandable to 5 handsets. It supports English prompts and is designed for simple residential use. Below are the key specifications, installation, operation, programming, and troubleshooting instructions.
Unpack the phone and ensure all components are present: base unit, cordless handset, battery pack (Ni-MH rechargeable), battery compartment cover, belt clip, telephone line cord, power adapter, user's manual. For battery installation: Insert the battery pack into the handset compartment (label "THIS SIDE UP"), then slide the cover into place. Charge new battery by placing handset in base cradle for 12 hours before first use. Maximum battery life: Up to 7 hours talk time, 7 days standby. Place base away from water, heat sources, and interference sources like microwaves. Expandable to 5 handsets.
WARNING! Failure to read and follow all instructions carefully before installing or operating this control could cause personal injury and/or property damage. Save these instructions.
The VTech 6727 is a 2.4GHz cordless phone with built-in answering machine (up to 99 messages, 22 minutes total storage), caller ID (subscription required), phonebook (50 locations), redial (last 10 numbers), adjustable volume (5 levels), ringer (5 melodies/OFF), and any key answer. Supports basic calling, paging, intercom between handsets, and remote access. Handset layouts include dedicated buttons for CID/>, REDIAL/PAUSE, VOL +/-, MUTE, PLAY/STOP, SKIP, REPEAT. The base has speakerphone; expandable to 5 handsets.
Applications: Residential cordless telephony with answering system; Multi-handset setup.
CAUTION! To prevent electrical shock/equipment damage, unplug before installation. Use only supplied adapters. If in doubt about wiring, consult qualified electrician.
WARNING! Do not use on circuits exceeding 120V AC; improper use can cause shock/fire. All wiring must conform to local/national electrical codes. Avoid use during storms, near gas leaks, or with medical devices (maintain 6-inch distance). Dispose of batteries per local regulations. Install DSL filter if using DSL/high-speed internet.
Plug telephone line cord into base and wall jack (use DSL filter if needed). Plug power adapter into base and unswitched outlet. Install battery in handset (align terminals, snap cover). Place handset in base to charge for 12 hours. For wall mount, attach bracket to base and wall plate, route cords through slots. Set up answering system: Use voice guide to set date/time and record announcement.
After charging, lift handset and listen for dial tone (wait 1-2 seconds). Test by dialing a number and adjusting volume. Verify CHARGE light on base.
Access phonebook with /VOL+/ (directory).
Caller ID: /VOL-/CID > Scroll > PHONE to dial > SELECT > PROG to save to phonebook.
Changes activate immediately.
Adjust via PROG: Date/Time, Ringer, Dial Mode, Home Area Code, Language.
| Setting | Default | Options | Comments |
|---|---|---|---|
| Ringer Tone | Tone 1 | 5 melodies | PROG > RINGER > Ringer tone > Sample > SELECT |
| Ringer Volume | Medium | OFF/HI/LOW | Hold VOL during idle or PROG > RINGER > Ringer volume |
| Handset Volume | Level 3 | 5 levels | Adjust during call |
| Language | English | English/Spanish | PROG > LANGUAGE |
| Dial Mode | Tone | Tone/Pulse | PROG > DIAL MODE |
| Quiet Mode | Off | On (24 hours) | Hold # to toggle |
| Voicemail Number | None | Up to 30 digits | PROG > VOICEMAIL # > Enter number > SELECT (hold # to retrieve) |
Set Time/Date: PROG > DATE/TIME > Enter MM/DD/YY, HH:MM > SELECT.
Clear Voicemail Indicators: PROG > CLR VOICEMAIL > SELECT.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Telephone does not work at all | No power, low battery. | Check adapters, charge 12 hours; unplug/replug power (15 sec); test with another phone. |
| No dial tone | Wiring issue. | Check line cord; test jack; contact provider for wiring/DSL/VoIP issues. |
| Poor audio quality | Out of range, interference. | Move closer; press CHAN; avoid electronics; install DSL filter; centralize base. |
| Cannot store numbers | Memory full (50 max). | Delete entries. |
| Handset does not ring | Ringer off. | Set ringer ON; check plugs; reinsert battery. |
| Voicemail indicators persist | Service provider messages. | Use CLR VOICEMAIL feature (does not delete messages). |
Handset Registration: Base: Press MENU > Register HS > Place handset in cradle.